Preset and Conversion Profiles Configurations EnterMediad 9.Preset and Conversion Profiles Configurations.Managing Metadata - Views and Asset Types.Hardware Requirements and Recommendations for EnterMediaDB 9.x.Setup NGINX as Proxy Forward and Load Balancer. Then run the following command to update the application data: $ sudo entermediadb update /opt/entermediadb Change the 'port' value of 'eventsserver' section to adjust port used by clients to report all file change events. I have a couple of shares, such as /mnt/pool/photos and /mnt/pool/work. Then you need to update the webapp.įor example, to switch from master to dev, use your package manager to uninstall entermediadb package and install entermediadb_dev. I cant figure out how to setup the Resilio to sync my SMB shares. You can go back and forth between master and dev branches by removing the one you don't want and installing the one you want. To test that the server is running you can use this command: $ wget (On Amazon make sure your security group enables the chosen port)ģ. To remove a site: $ sudo entermediadb delete /opt/entermediadbĤ. Once the web server is installed you will need to setup a firewall or nginx to forward port 80 to your chosen port. For the purposes of this guide, we will assume you chose the defaults (port 8080, data at /media/data, and application at /opt/entermediadb).Ģ. You should not use any port number lower than 1024. You will be prompted to provide the folder, data and port number that will be used (such as 8080). Installing an instance of EnterMediaDB can be done with a simple command: $ sudo entermediadb install If you have not, please visit the downloads page for instructions.ġ. This doc assumes that you have already installed the EnterMediaDB application for your OS.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |